How to license pcmscan1/28/2024 Then you need the laptop software (PCMSCAN £60 above or ScanXL etc) that connects to the CARs ecu via the hardware/cable. No the hardware is a datacable (obdlink £80 above) which connects a laptop to a cars OBD port under the dash between center console and steering wheel.Īll this does is allow the computer to talk to the car. Hopefully I'll be able to pull swirl valve % readings and EGTs with a bit more reading up if these are the available not supported items. Yet the software says not supported when reading some.Īmong these is catalyst and secondary air support. Mass Air Flow Rate in lbs/minute (as per Turbo tables)įuel rail pressure in psi (should be able to change this to kpa = 1/100th bar)Īll the parameters listed below are available according to the ECU. but you can see the parameters I managed to read.Ĭalculated Load (not sure exactly what this is yet)īoost Pressure in psi (need to see if this is before or after intercooler) Haven't had a chance to setup the virtual dash yet. I'll do some logging in the next few days. Only idling for a while to aggressively search the ecu. Only had a chance to scan live ECU for available parameters at the moment. no license code was the nt through today. Got my ODBII data cable and the PCMSCAN software to go with.Ĭould only read rpm to begin with.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |